Samples:
|
|
|
Supplies:
ClinkIts!
Suze Weinburg's UTEE (your choice of color) or other similar product
Embossing pad
Needle Tool, acrylic paints, paintbrushes, papertowels
Heat Gun
Wire, beads, wire cutter, needle nose pliers, pin backs, strong craft glue.
Instructions:
1. Place ClinkIt on a heat safe surface. (I use a piece of thick cardboard with nonstick foil on it)
2. Heat ClinkIt for a minute. Sprinkle on Thick Embossing Powder.
3. Heat with heat gun, only start with the gun really high, so you don't blow all of your powder away. As you continue to heat, gradually bring the gun closer to the the piece until the powder is melted.
4. repeat until you have a thick layer.
5. Cover your stamp with clear embossing ink.
6. When powder is hot and melted, press stamp lay stamp into powder and leave sit for 5 minutes.
7. Remove stamp and clean edges of ClinkIt.
8. Using an old toothbrush, scrub some black acrylic paint into the crevices of embossing powder. Use a damp paper towel to wipe the raised surfaces clean. You can further accent the raised surfaces by using your finger to brush a bright or metallic acrylic paint across.
9. Let dry. Accent with wire and beads if you wish.
10. Add Pinback.
Visit Alicia G's Site to see all the available ClinkIts!
